Walking on the road and looking up, you can see wires and poles everywhere on the fence, which is what we often call an "electronic fence".

But do you know that the basic installation method of electronic fences is not only to install them on the walls

Today, let's take a look at the basic installation types of pulse electronic fences according to the latest national standards. There are a total of 2 types!

　　Accessory installation

The distance between the top metal conductor of the pulse electronic fence attached to the upper or inner part of the wall or fence and the top of the wall or fence should not be less than 800mm.

　　Floor standing installation

A protective net or fence of no less than 1.2m should be installed on one or both sides of the front end of the pulse electronic fence to prevent human error.

The specific steps for the two installation types are summarized in the above figure.

In the future, we will also popularize the installation methods of more difficult electronic fences in special environments.

Special environments include high and low undulations, large wall piers spanning, wall filling lines with height differences, blind spots on the edge of the river, many twists and turns, gate fences, and so on.