Drawer opening and closing test machine

‌1Introduction‌

The drawer sudden opening and closing test machine is suitable for testing the durability fatigue test and sudden opening and closing test of drawer guide rails. durability test:Place a certain load on the drawer fixing component and repeatedly pull out and close the drawer. After a certain number of cycles, check whether the guide rail can still meet the usage requirementsCertification standards‌Intelligent Control and Data Management‌

PLC+WindowsControl system, supporting custom testing standards;

Built in micro printer for instant output of results,USB/RS485Interface with computer software for real-time data analysis.

‌2、 Key pointparameter‌

‌IIIexecuteStandards and Applicable Scenarios‌

Compliant with standards:

strictly adhere toGB/T 10357.5-2023The testing items are as follows:

1.Strength of drawer structureWill cracking, deformation, or damage occur.

2.slide/Durability of the guide rail system: whether it can withstand repeated impact loads.

3.The firmness of connectors: whether screws, buckles, etc. are loose or ineffective.

4.The coordination between drawers and cabinets: whether they can still open and close normally after being abruptly closed, and whether there is any misalignment or jamming.

5.Security:Will drawers or their contents accidentally come out

‌Typical Applications‌：

Furniture manufacturing enterprisesBatch production before leaving the factoryCabinet typeThe product undergoes sampling testing to ensure compliance with national standards/Standard requirements.

Quality Inspection Agency: For Market SalescabinetClass productsdrawerConduct quality inspections and identify non-conforming products.

Research institutions: used for early optimization of design schemes to avoid“Excessive design”or“design deficiency”.

‌4、 Example of Operation Process‌

Mengguan Test

Method: Release the drawer from its fully open position (or specified opening limit, such as two-thirds depth) and allow it to quickly close under its own gravity or additional force, hitting the stopper behind.

Cycle times: According to standard regulations, it is necessary to perform 10,000time Cycle.

Simulation scenario: Simulate the user pushing up the drawer and releasing it, and then the drawer“Bang”A collision action.

Fierce opening test

Method: Move the drawer from the closed position, apply a momentary tensile force through the testing machine to quickly accelerate it to the fully open position, and impact the opening limit device (if any).

Cycle times: Same as before10,000time Cycle.

Simulation scenario: Simulate the action of a user quickly pulling out a drawer with force.

Note: Detailed parameters such as test sequence, specific applied force or speed, drawer opening stroke, etc., shall be includedGB/T 10357.5-2023There are clear regulations and calculation formulas in the document, which must be strictly followed.

Configuration List

host1Taiwan;

test software1Set;

instruction manual1share;

Certificate of Conformity1share;

Warranty Card1share;

Delivery Receipt1share;

nameplate1block;

power cord1root;

wrench1set;

Several brochures;