After heating, the HW-7.6 bearing heater expands the bearing outward in the cylindrical direction, which can avoid damage during installation. Induction heating is a heating method that does not require preheating. Bearings of different weights can be heated to 120 ℃ in seconds or minutes without damaging the pre lubrication.

　　Product Features

1: Connect the power according to the requirements, and the host will automatically detect the probe and ambient temperature, and display the ambient temperature at the same time.

2: Press the function button to select temperature or time control. To adjust the temperature or time, press the up or down button to select the appropriate parameters. When selecting temperature control, attach the magnetic probe to the outer side of the bearing inner ring. The maximum heating temperature of the bearing should not exceed 120 ℃

3: Press the start button, and the host will start heating the workpiece. At the set time, the host will automatically stop heating and demagnetize the workpiece. During temperature control, when the set temperature is reached, the workpiece is in a constant temperature state. When it needs to be installed, simply press the stop button.

4: Remove the workpiece to install.

5: Heating the same workpiece, please use time control and automatically remember the time required for the last heating.

　　Product Matters

1: The bearing heater automatically detects the probe in temperature control mode. If there is no probe, it cannot be started;

2: It is strictly prohibited to start without putting on the sleeve yoke;

3: When heating workpieces, it is advisable to choose a suitable sleeve yoke to improve work efficiency;

4: The maximum temperature of the bearing should not exceed 120 ℃;

5: Please wear high-temperature resistant asbestos gloves when taking away workpieces to prevent burns;

6: Please do not place the probe on the workpiece for a long time to extend its service life.