DGS series mining LED tunnel lightsAdvantages of
1. The electronic integrated circuit used for mining LED tunnel lights has a wide voltage design and a wide range of operating voltage variations. It can work normally with voltages ranging from 85V to 265V. The light source adopts DC and low-voltage power supply, without flicker and electromagnetic interference, no red (ultraviolet) radiation, no mercury vapor and other pollutants in fluorescent lamps. It meets the future lighting production standards of the European Union and is a safe and healthy lighting source with obvious environmental protection effects.
2. Extremely low power consumption, under the same illumination, the power consumption is 1/10 of incandescent lamps and 1/2 of energy-saving fluorescent lamps, with significant energy-saving effects.
3. It has the characteristics of reasonable structure, beautiful appearance, small volume, light weight, explosion-proof, shock and vibration resistance, moisture and heat resistance, good sealing, and maintenance free.
4.DGS series mining LED tunnel lightsThe design of separate chambers for power supply, light source, and wiring makes the entire lamp not only aesthetically pleasing, but also easy to install for mining LED tunnel lights. It greatly improves the explosion-proof, impact resistant, vibration resistant, and heat resistant performance of the lamp, and all indicators meet the national and industry standards for mining explosion-proof lamps.
Precautions for using mining LED tunnel lights
1. During transportation, the mining LED roadway lamp shall be installed in the equipped carton, and foam shock absorption shall be added.
2. When installing mining LED tunnel lighting fixtures, the fixtures should be safely grounded nearby.
3. When in use, there is a certain temperature rise on the surface of the mining LED tunnel light fixture, which is a normal phenomenon; The center temperature of the transparent component is high and should not be touched.
4. MaintenanceDGS series mining LED tunnel lightsAt this time, the power must be disconnected first.