Installation of BAT52-L250W explosion-proof floodlight effect in the grain silo

A metal halide lamp is a discharge lamp that operates on an AC power source and produces arc discharge light in a mixture of mercury and rare metal halides. Metal halide lamps are third-generation light sources made by adding various metal halides to high-pressure mercury lamps. The lighting adopts scandium sodium type metal halide lamps, which have the characteristics of high luminous efficiency, good color rendering performance, and long service life. They are an energy-saving new light source close to daylight color.

Performance characteristics

1. The light source adopts the Yaming brand, which has a long lifespan, reliable performance, and brightness 10%~20% higher than similar products, saving the trouble and inconvenience of frequent bulb replacement.

　　2. The transparent parts have been optimized and processed, with soft light, uniform illumination, and no ghosting, effectively avoiding eye discomfort and fatigue during operation.

　　3. Exquisite structural design, good heat dissipation performance, effectively reducing the body temperature of the lamp and improving its service life.

　　4. Has good electromagnetic compatibility and will not cause any interference to various electrical appliances and transmission networks.

　　5. The shell adopts high-tech surface spraying technology, which is wear-resistant, corrosion-resistant, waterproof and dustproof, suitable for various harsh environments.

　　6. The shell is made of imported lightweight alloy, supplemented by multiple pressure reducing seismic design, with good impact resistance performance.

　　7. Multiple installation methods such as seat, ceiling, wall mounted, etc. are safe, simple, and convenient.

Determine the installation position and method of the lighting fixtures according to the actual needs of the work site, and then prepare the corresponding length based on the distance from the lighting fixtures to the power contactsThree core cable with a diameter of 8 to 14 mm.

Open the end cover of the ballast, loosen the clamping nut of the ballast cable inlet, thread the lamp cable and power cable through the clamping nut and into the internal wiring terminal of the ballast, connect and fix them, and then tighten the cable clamping nut and the ballast end cover separately.

Install the lamps and ballasts according to the determined installation position and method, and then connect the other end of the ballast input cable according to explosion-proof requirementsA 220V power supply is sufficient for lighting.

Loosen the screws at the bottom of the lamp holder bracket to move the lamp holder bracket left and right360 ° rotation adjustment of lighting direction; Loosen the screws on both sides of the lamp holder bracket, adjust the lighting angle of the lamp holder up and down according to the lighting needs, and then tighten the screws.

[1] When replacing the light bulb, use a suitable screwdriver or other tool to insert it into the two protruding holes on the side of the front cover, unscrew the front cover, remove the faulty light bulb, and replace it with a new one.

Precautions for editing this paragraph

　　1. During transportation, the lamps shall be installed in the cartons provided, and foam shall be added for shock absorption.

　　2. When installing and maintaining lighting fixtures, the power must be disconnected first.

　　3. When in use, there is a certain temperature rise on the surface of the lamp, which is a normal phenomenon; The center temperature of the transparent component is high and should not be touched.

　　4. When replacing light bulbs, use bulbs of the same type and power; If the type or power of the light bulb is changed, the matching ballast should be replaced accordingly.

Edit this paragraph for security warning

　　1. It is strictly prohibited to turn on lighting fixtures with electricity on.

　　2. Non professionals are not allowed to install or dismantle lighting fixtures and ballasts at will.