ZB-10, ZB-11 resistive rotary level switch

Brief introduction
The working principle of the anti rotation level switch is to use a permanent magnet motor to drive the blades to rotate. When the detected material rises to the blade position, the blade rotation is blocked, and the resistance is transmitted to the detection device inside the junction box. The detection device then outputs a switch signal to the outside and cuts off the power to stop the blade rotation.

Detailed introduction of the rotary material level switch
The working principle of the anti rotation level switch is to use a permanent magnet motor to drive the blades to rotate. When the detected material rises to the blade position, the blade rotation is blocked, and the resistance is transmitted to the detection device inside the junction box. The detection device then outputs a switch signal to the outside and cuts off the power to stop the blade rotation.
When the material level drops, the blade resistance disappears, and the detection device relies on the tension of the spring to return to its original state. The spring tension is adjusted for different material densities. When the density is high, the spring tension is adjusted to strong or strongest, and vice versa, it is adjusted to weak or weakest.

Product Description:
1. Power supply: 220VAC/110VAC/24VAC 50Hz/60Hz
2. Power: 3W
3. Contact capacity: 8A/250VAC SPDT
4. Working temperature: -10~80 ℃ (customized up to 400 ℃, * up to 1000 ℃)
5. Blade speed: counterclockwise 1rpm
6. Rotation torque: 1N. m
7. Applicable material specific gravity: ≥ 0.4g/cm3
8. Protection level: IP65
9. Blade material: SUS304
10. Outlet: M20&# 215; one point five

characteristic:
1. Fully enclosed, can also be used outdoors
2. The oil seal design of * can prevent dust from infiltrating along the axis
3. Stable and reliable torque, adjustable cutting torque size
4. Lightweight and easy to install
5. The blades bear excessive loads, and the motor rotation mechanism will automatically slip to protect them from damage
6. It is easy to inspect and repair internal parts without dismantling the entire set from the bucket groove

Ordering precautions:
1. Confirm voltage 24Vac, 110V, 220V OR 240V, 50/60Hz
2. Confirm installation method (side or top)
3. Pay attention to the proportion of raw materials
4. Confirm if the blade size can be inserted into the flange inlet or barrel wall opening

ZB-10, ZB-11, ZB-20, ZB-30, ZB-40, ZB-41, ZB-50, ZB-70, ZB-80, ZB-84 resistive rotary level switches