Chinese herbal slices are specially designed and produced for ginseng shops, pharmacies, clinics, and households to cut ginseng, deer antler, gastrodia elata, and other ginseng medicinal materials. This machine can cut into oblique, horizontal, and straight pieces, with uniform thickness and beautiful color. Install two blades on the disc, which can be adjusted in thickness as desired It has the advantages of small size, easy use, beautiful slicing, simple operation, stable quality, and long service life. Suitable for slicing ginseng, gastrodia elata, and other valuable medicinal herbs, it is a choice for traditional Chinese medicine rooms, pharmacies, and processing plants.

Product Features: Traditional Chinese MedicineslicerGood stability, high precision, easy to operate, and continuous and uniform slicing.

1. Power: 0.3KW

2. Slicing frequency: 720 slices per minute

3. Motor speed: 1400 revolutions per minute

4. Slice thickness: 0.3-3mm

5. Weight: 12kg

6. Voltage: 220V

7. Dimensions: 300/180/240 mm

　　Detailed introduction of traditional Chinese medicine slicer:

　　① Instructions for using traditional Chinese medicine slicer

This machine is equipped with a single-phase motor, bearings, and four blades installed on the disc. It has a slow speed ratio and high slicing efficiency. The slicing thickness can be adjusted, and it is widely used in traditional Chinese medicine pharmacies, drugstores, and Chinese medicine processing plants. This machine has the characteristics of small size, high efficiency, easy operation, exquisite and beautiful appearance, and is both energy-saving and safe.

　② Instructions for using a small slicer

1. Adjustment: When adjusting, first loosen the fixed copper column nut, then rotate the nut to adjust the thickness direction on the copper column. After adjusting the thickness, the nut must be tightened to the copper column. If the disc is parallel to the blade, do not turn on the machine. The cutterhead must be lower than the blade in order to start cutting. Adjust the thickness to about 3mm, and the thickness to be infinitely adjustable.

2. Replace blade: Insert the hexagonal handle into the hole on the side of the machine. Rotate to adjust the direction of the wheel before changing the knife. When changing the knife, loosen the two hexagonal screws of the blade and insert the blade for replacement.

　③ Precautions for Slicer

1. The knife basin should be regularly oiled to avoid sticking dirt. If there are pills with tails or fine fragments, it indicates that the softening is not appropriate or the blade is not sharp, and must be replaced or sharpened. It's too thin to cut properly.

2. Slicing sticky materials such as sweet clouds, raw earth, ginseng, gastrodia elata, etc. with water on the surface.

　　Chinese medicine slicerCommon faults and maintenance methods:

　The motor does not run after being powered on

Reason: ① Poor power contact or loose plug; ② Poor switch contact

Repair method: ① Repair the power supply or replace the plug; ② Repair or replace switches of the same specifications

　　2 slices are uneven, lack luster, and produce a lot of powder

Reason: ① The blade is not sharp; ② The hardness of the sliced material is too high; ③ The adhesive juice of the sliced material sticks to the blade; ④ Uneven application of force

Repair method: ① Remove the blade and sharpen it with a grinding stone; ② Dry the sliced material until soft; ③ Remove the blade and grind off the sticky juice; ④ Apply even force when slicing

　When working, the motor stops rotating

Reason: ① Excessive feeding caused the cutter head to get stuck; ② Poor switch contact

Repair method: ① Check the cutterhead and remove the stuck material; ② Switch contact adjustment or switch replacement