Planing machine

ZY-1008Rubber and plasticPlaning machine

1Performance and Application

In order to cooperate with various levels of testing institutions and wire and cable manufacturers to better implementGB/T529-2008General Test Methods for Wire, Cable and Sheath MaterialsGB/T529-2008Under the guidance of experts from Shanghai Cable Research Institute, a cable punching and slicing machine (also known as a slicing machine) has been developed to meet the new requirements for mechanical and physical performance testing of polymer insulation and sheath materials in the standard. This machine adopts a series of technologies that enable the blades to be placed horizontally, replaceable and grindable, meeting the requirementsGB/T529-2008Requirements for the operating principle of the equipment used for sample preparation in China. Test personnel need to read carefullyGB/T529-2008Read the relevant chapters of the standard carefully, understand the usage instructions of this machine, master the specific operating steps and precautions, in order to prepare high-quality test pieces.

This experimental slicer is a device used for testing rubber and plastic product factories. Using mechanical transmission feeding and blade cutting structure, capable of cutting 2-12Soft plastic and rubber sheets of various thicknesses within the millimeter rangeRubber waterstops can also be used for slicing some rubber and leather materials. This machine is widely used in rubber, plastic, leather, wire and cable manufacturers, scientific research and other units.

This machine is suitable forGB/T529-2008Standard for General Test Methods for Wire, Cable and Sheath MaterialsPreparation of test samples for mechanical and physical properties testing of polymer insulation and sheath materials for designated cables and communication cables, including marine cables.

IIMain technical specifications

Workbench width160mm

Slice width Not greater than100mm (recommended 25-35mm depending on different materials)For the best)

Slice thickness1-12mm

Maximum feeding thickness20mm

MotorY100-8；1.1Kilowatt910turn/Divide;380Fu

External dimensions longX Width x Height460×490×1100mm

Net weight 115kg .

IIIStructure and usage

This slicer consists of the body, transmission, adjustment, and control parts. The structure and usage of each part are introduced as follows:

1、Body and transmission

The lower part of the body is the machine base, which is equipped with an electric motor and electrical accessories inside. The outer part is equipped with an emergency stop switch for starting the electric motor. The upper part of the body is the working part, which is equipped with left and right frames, workbenches, clamping shafts, feeding shafts, and adjustment structures.

When working, start the switch, turn on the motor, the slicer starts running, and the stop switch stops the slicer.

The transmission is driven by a motor, and the main and auxiliary pulleys drive the transmission shaft to rotate. The gears installed at both ends of the transmission shaft respectively drive the lower and upper feeding shafts to rotate, and then the gears on the upper feeding shaft drive the compression shaft to rotate simultaneously.

2、Manipulation and adjustment

The right-hand operating handwheel is usually used for adjustment. When working, this wheel rotates empty. To adjust the thickness of the slice, the system rotates the adjustment handwheel above the frame, which rises (or falls) through the transmission system's clamping shaft and the upper feeding shaftTo the required slice thickness. Adjust the thickness of the handwheel to2Millimeters.