Jiangsu cable hot air dryer manufacturer

The cable hot air dryer is used for drying rubber sheathed cables. Its principle is to filter and heat compressed air and press it into the cable sheath and core, forcing moisture or water to be discharged from the cable body, thus drying the cable. It is an ideal equipment for drying cables in coal mines, iron mines, construction wells and other units. This machine consists of a compressor, filter, heating cylinder, seal, etc. It adopts instruments, light indicators, automatic heating and pressurization devices, which are safe to use, easy to move, labor-saving, energy-saving, reliable in operation, fast in work efficiency, and have excellent performance.

1、 Operating procedures

1. After connecting the power supply during work, turn on the main power and adjust the temperature controller to the temperature required for heating the cable.

2. After heating up, turn on the air filter switch to allow air pressure to pass through the electric heating box, and turn on the wire switch to allow dry hot air to be pressed into the cable.

2、 Precautions during drying

1. When drying with hot air, attention should be paid to the temperature values of electromagnetic preheating and changes in coil current at all times. The index of the thermometer should not exceed 60 degrees, nor should it be lower than 35 degrees, and should be kept within the above range. （Jiangsu cable hot air dryer manufacturer）

2. After the cable has been dried for a period of time, a megohmmeter can be used to measure its insulation resistance at the exposed ends inside and outside the cable. If the drying effect is good and the insulation resistance can reach 150-250 megohms, the drying can be stopped. If the drying effect is slow after several cycles, the cable can be turned around and dried again until it meets the requirements.

3、 Basic parameters

Dimensions: 1600 × 600 × 1100mm

Weight: 300kg

Working voltage: 220V

Heating power: 2-5kw

Model: GH-DGZJ Cable Hot Air Drying Machine

Cable cross-sectional area: 4-110cm2

Cable length: 500m

Drying temperature: 30-50 ℃

Drying time: 8h

Applicable wind pressure: 0.1-0.4Mpa（Jiangsu cable hot air dryer manufacturer）