SA-9200 Low Frequency Vibration Sensor

NegotiableUpdate on 01/09

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The SA-9200 low-frequency vibration sensor is mainly used to measure the vibration of water turbine generators, low-speed rotating machines, engineering buildings, and bridges. The vibration measured by this sensor is relative to the vibration in free space. Its output voltage signal is proportional to the amplitude of the vibration.

Product Details

Usage characteristics:

1. The sensor has a very low frequency of use and can be applied to low-speed rotating machines.

Compared to other types of vibration sensors, CZ960 sensor has lower output impedance and better signal-to-noise ratio.

3. Friction active components have been removed from the sensor design, resulting in a relatively long service life.

Basic technical parameters

Frequency response:0.5Hz～80Hz（-3dB）

spirit Min Degree:8V/mm ± 5% (or adjusted according to user requirements)

Power supply:+24Vdc、-24Vdc、±12Vdc

Measurement range:±1mm

line sex Degree:< 5%

Temperature range:-30℃～ 80℃

Installation method: Use one in the center hole of the baseM10 bolt fixation

Precautions for use

1.low frequencyvibrationsensorWhen installing, be sure to pay attention to the horizontal and vertical sensors, and do not mix them.

During transportation and installation of sensors, unnecessary vibrations and impacts should be avoided as much as possible, especially lateral vibrations and impacts.

When connecting cable plugs, be sure to be careful and not connect them incorrectly, otherwise the sensor will be burned.