Manufacturers produce biomass energy combustion machines without tar wastewater discharge

Manufacturers produce biomass energy combustion machines without tar wastewater discharge

1.Personnel operating boilers should undergo professional training and obtain operating certificates;
2.Boiler installation or renovation must be carried out by a qualified company and obtain a usage license;
3.Before preparing for use, the boiler must undergo a single machine trial run and a detailed understanding of the characteristics and operating instructions of the boiler and combustion engine;
4.The boiler is prohibited from using beyond the design specifications and the normal operation of safety protection settings is forcibly restricted
Make;
5.Installation, use, maintenance, and upkeep must be carried out in accordance with the corresponding national regulations;
6.Boiler equipment must have a dedicated person on duty during operation;
7.The appearance of the combustion engine should be regularly cleaned of surface wood dust after use to avoid ignition and fire;
8.The blowing blades of the air supply fan should be regularly cleaned with high-pressure air to avoid long-term accumulation of dust affecting the air supply volume or causing noise;
9.The feeding bearing should be regularly lubricated with butter to ensure that the bearing lubrication does not get stuck;
10.If the oil igniter fails to ignite repeatedly, it should stop ignition and wait for the ignition system to be repaired before reigniting to avoid excessive diesel accumulation in the furnace;
11.The inner pipe of the fire outlet may cause a certain degree of coking after a certain period of use. Please regularly disassemble the inner pipe for cleaning;
12.This biomass burner design is only applicable to pure wood pellet fuel. Do not use other materials of fuel to ensure the normal operation of the unit.

Manufacturers produce biomass energy combustion machines without tar wastewater discharge

1、 Before starting the combustion engine, clean the carbon deposits on the furnace bridge and bottom, add granular fuel, close the material box cover, and open the isolation valve;

2、 Turn on the power supply of the device, check if the circuit and water pipes are normal, and check if the cooling water tank has enough water. Open the cooling water inlet and outlet valves of the combustion engine and confirm that the interlayer cooling water of the high-temperature combustion chamber is filled;

3、 Adjust the air supply level to a lower level, add an appropriate amount of bottom material, start the ignition officially, gently open the furnace door to supply air appropriately, close the furnace door, start the feeding system, and gradually increase the air supply level to an appropriate level. The feeding speed and air volume should gradually increase, and should not be accelerated too fast2-3Minute time to allow the furnace temperature to rise normally.

From the perspective of thermodynamic principles, biomass pellet fuel stoves have basically reached3One condition:

One is the ability to fully burn fuel, converting the chemical energy in the fuel into heat energy more efficiently;

Secondly, it has good heat transfer and insulation effects, which increases the effective utilization of heat value and reduces the heat dissipation heat value;

Thirdly, waste heat can be effectively utilized to minimize exhaust waste heat and other heat losses, while solid fuels can withstand high temperatures Under hypoxic conditions, gasification can be achieved with reasonable control of the excess air supply coefficient. Therefore, this stove In research and design, the lower part of the furnace (gasification section) is designed as a basically closed system that supplies air The gas volume can be adjusted to achieve a significant gasification effect of the fuel. With good gasification effect, sufficient gasification should be ensured during combustion The air is used to support combustion, ensuring an appropriate operating temperature. A secondary air intake ring (combustion) is designed in the upper part of the furnace Many secondary oxygen supply small holes are evenly distributed on the ring belt, greatly enhancing the full combustion of gasification fuel and enabling The burning flame is bright white.