Mecalectro electromagnet P-.7.12-44 has a simple installation method

NegotiableUpdate on 01/08

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The installation method of the French Mecalectro electromagnet P-.7.12-44 is simple. These fixed devices have two holding modes: fail safe (power-off) and fail safe (power on), which comply with the requirements of NF S 61-937 standard and are used to keep fire doors open. They can be installed on walls or floors, with hinged or fixed base plates, and with or without door detection function.

Product Details

FranceMecalectro electromagnet P-.7.12-44 has a simple installation method

Main products:

Mecalectro Electromagnets

Mecalectro fixed magnet

Mecalectro electromagnetic lock

Mecalectro electric push rod

Mecalectro Robot Clamp

Parameter Overview

• Holding force: 20 daN (≈ 200 N), can continuously close the fire door in the event of power failure

Rated voltage: 48 V DC (compatible with 24 V DC dual voltage scheme for easy on-site switching)

Steady state power consumption: only 3 W, low heat generation during long-term operation, significant energy savings

• Size: Ø 42 mm × 54 mm, cylindrical design, easy to embed into door frames or lock boxes

3、 Safety and Regulations

The product complies with NF S 61-937 standard and is designed specifically for the "Fail safe" scenario of fire doors

• Power outage maintenance: Even if the power is cut off during a fire, the door can still be fixed in the open/closed position to ensure unobstructed escape routes or prevent the spread of smoke and fire.

• Protection level: IP40, meeting the dust prevention requirements of indoor public areas.

• Heat resistance level: B-level insulation, long-term stability under -5 ° C~+40 ° C working conditions.

4、 Installation and maintenance

Installation direction: It can be fixed at any angle, supports wall or floor installation, and is compatible with hinged/fixed bottom plates.

Maintenance free guide bearings: pre lubricated at the factory, requiring no additional maintenance during their lifecycle, reducing TCO.

• Wiring method: Standard 2-wire system, combined with fire door release button or fire linkage module to achieve remote release.

5、 Typical application scenarios

The emergency exit fire door should be kept normally open

Evacuation channel control in crowded places such as subways, airports, hospitals, etc

Secondary insurance for airtight doors in negative pressure areas of clean rooms and laboratories

6、 Extended compatibility

The same series provides power subdivision models such as P-.7.18-.44 (3.5 W/20 daN), and users can flexibly choose according to the weight of the door and the power system.

7、 Certification and Standards

Design System: EN 9100/ISO 9001/ISO 14001 Full Process Quality Control

Coil protection: shockproof and moisture-proof coating, protecting against the risk of wire breakage caused by handling or long-term vibration.

FranceMecalectro electromagnet P-.7.12-44 has a simple installation method